JLG TF6-42 Service Manual - Manuale (Pagina 852)

T12000 ID 04/99 10-71
Reassembly converter housing
Figure 364
Apply a very light coat of Permatex #2 to
the outer diameter of the converter housing
oil seal. Press seal in housing with lip of seal in.
Refer to the cleaning and inspection pages.
Figure 365
Install oil distributor in converter housing with long
hub towards oil seal.
Figure 366
Press converter bearing in housing against shoulder.
Figure 367
Install 1st and 2nd clutch shaft oil distributor sleeve
in converter housing, with inside diameter chamfer
up, and the notch in the distributor aligned up with
the retaining set screw hole in the converter housing.
Figure 368
Apply Loctite #243 to threads of sleeve set screw
(NOTE: this screw has a hole in it. Use caution as
not to allow any loctite to plug hole). Install set screw
in converter housing and in oil distributor.
Figure 369
Install set screw plug.