JLG TF6-42 Service Manual - Manuale (Pagina 832)

T12000 ID 04/99 10-51
Reassembly reverse clutch
Figure 268
Install clutch disc end plate.
Figure 269
Install end plate retainer ring.
Figure 270
NOTE: reverse clutch pack must be checked for clutch disc
clearance. Stand the clutch assembly on end. The clutch disc on
the bottom will fall to the end plate. Measure the distance between
the clutch piston and the first steel disc by inserting a feeler gauge
or taper gauge through the slots in the clutch drum. The required
clearance is .048-.108 [1,22-2,74]. If the clearance is greater than
.108 [2,74] add one steel disc under the end plate.
Figure 265
Use a sleeve with the proper inner diameter to fit over
shaft and against retainer ring. A sharp blow with a
soft hammer will compress springs and seat retainer
ring. Be sure ring is in full position in groove.
Figure 266
Install first steel (outer) clutch disc.
Figure 267
Install first friction (inner) clutch disc. Alternate steel
and friction until six (6) steel and six (6) friction discs
are in position.
REV
FWD
Gauge