JLG TF6-42 Service Manual - Manuale (Pagina 660)

T12000 ID 04/99 4-1
4. MAINTENANCE
4.1 OIL SPECIFICATION
4.1.1 Recommended lubricants
1. Caterpillar TO-4.
2. John Deere J20 C, D.
3. Military MIL-PRF-2104G.
4. Allison C-4.
5. Dexron* II Equivalent - See note below.
Note
D
EXRON
* II
EQUIVALENT IS ACCEPTABLE
;
HOWEVER IT IS NOT COMPATIBLE WITH TORQUE CONVERTERS OR
TRANSMISSIONS EQUIPPED WITH GRAPHITIC FRICTION MATERIAL CLUTCH PLATES .
Caution
D EXRON * III, E NGINE OIL OR GL-5 OILS ARE NOT RECOMMENDED .
PREFERRED OIL VISCOSITY
It is recommended that the highest viscosity monograde lubricant available be used for the anticipated
ambient temperature. Typically this will be a CAT TO-4 qualified lubricant. When large swings in ambient
temperature are probable, J20 C, D multigrades are recommended. Multigrade lubricants should be applied
at the lower viscosity rating for the prevailing ambient temperature, i.e. a 10W20 should be used where a
10W monograde is used. If a C-4 multigrade is used in stead of J20 lubricant it is recommended that the
viscosity span no more than 10 points, i.e. 10W20.
Caution
S YNTHETIC LUBRICANTS ARE APPROVED IF QUALIFIED BY ONE OF THE ABOVE SPECIFICATIONS .
O IL VISCOSITY GUIDELINES APPLY , BUT SYNTHETIC MULTIGRADES MAY SPAN MORE THAN 10 POINTS .
F OR FIRE RESISTANT FLUID RECOMMENDATIONS PLEASE CONTACT
SPICER OFF-HIGHWAY PRODUCTS.
Recommended SAE J300 Viscosity Grade Based on Prevailing Ambient Temperature
-40 -30 -20 -10 0 10 20 30 40 50
-40
Celsius
SAE OW20
Dexron* II or equivalent.
SAE 10W
SAE 20
SAE 30
SAE 40
Fahrenheit -22 -4 14 32 50 68 88 104 122