JLG TF6-42 Service Manual - Manuale (Pagina 440)

Heat the bearing in oil at an approx. temperature of 100ëC and fit
the entire bush (13) on the u-joint (4).
Fit the check ring (9) on the bushing unit (13); also put the O-ring
(14) into position.
Insert the u-joint and tighten the top and bottom dowels (2).
Torque wrench setting: Max. 15 Nm.
NOTE. For u-joint coming with a bush, centre the point of the check
dowels in the slot.
Apply Loctite 242 to the jutting parts of the dowels (2).
Screw the check nuts (3) of the dowels (2) and lock them using a
dynamometric wrench.
Torque wrench setting: 122 Nm
GB GB
GB GB
GB GB
a b
c d
f e
38
INSTALLATION OF U-JOINT - INSTALLAZIONE DOPPIO GIUNTO CARDANICO - DOPPELGELENKWELLE INSTALLIEREN -
INSTALACION SEMIEJES - INSTALLATION DE JOINT DE CARDAN DOUBLE
F1240378
4
13
F1240371
13
9
14
F1240379
2
F1240380
2
F1240381
3
D1240082
2 3 3 2