JLG TF6-42 Service Manual - Manuale (Pagina 209)

20
Press the ‘S’ button to start the accelerator pedal sensor calibration.
The display shows:
The driver should release the throttle pedal completely and then press the ‘S’ button.
Now, the display looks as follows:
The driver should press the throttle pedal completely and hold it while pressing the ‘S’ button. As long
as one of the led display segments is blinking, the throttle pedal is not pushed hard enough and
pressing the ‘S’ button will not continue the calibration process.
When the calibration process is completed and no errors are encountered during the process, the
calibration results are memorized in flash memory and will become active at the next power-up of the
controller. The display looks as follows:
When errors are detected during the calibration process, the calibration results are ignored and the
display looks as follows:
Pressing the ‘S’ button once again returns the display back to the start of the currently active display
mode, allowing the user to re-calibrate the current sensor or to use the ‘M’ button to proceed with the
next calibration mode.
4.2.2 Calibration of the Joystick Sensor
Enter stand-alone calibration mode and push the ‘M’ button until the display shows:
Press the ‘S’ button to start the joystick sensor calibration.
The display shows: