Intel BLADE SERVER IXM5414E - Manuale (Pagina 222)

Command Line Interface Management 199
config spanningtree port mode
Use this command to configure the Administrative Switch Port State to a new value for the specified
port. The <port> parameter specifies the port(s) to be affected. To enable or disable all ports with a
single command, <all> can be specified. Note that a maximum of 4095 ports can be enabled.
Default disable
Format config spanningtree port mode <port/listofports/all> <enable/disable>
show spanningtree port
Use this command to display the STP statistics for a specific switch port.
Format show spanningtree port <port>
Port mode Enabled or disabled.
Port Up Time Since Counters Last Cleared
The time in days, hours, minutes, and seconds since the counters were last reset.
STP BPDUs Transmitted
The number of STP BPDUs sent by this port.
STP BPDUs Received
The number of STP BPDUs received by this port.
RSTP BPDUs Transmitted
The number of Rapid Reconfiguration STP BPDUs sent by this port.
RSTP BPDUs Received
The number of Rapid Reconfiguration STP BPDUs received by this port.
Spanning tree summary commands
config spanningtree adminmode
Use this command to configure the STP operational mode. While the operational mode is disabled,
the spanning tree configuration is retained and can be changed, but it is not activated.
Default disable
Format config spanningtree adminmode <enable/disable>
config spanningtree forceversion
Use this command to select which version of the STP will be used. The <version> can be one of the
following:
• 802.1D - IEEE 802.1D functionality supported: STP BPDUs are transmitted rather than
R(Rapid)STP BPDUs
• 802.1w - IEEE 802.1w functionality supported: RSTP BPDUs are transmitted rather than STP
BPDUs
Default IEEE 802.1D
Format config spanningtree forceversion <802.1D/802.1w>
show spanningtree summary
Use this command to display STP settings and parameters for the switch.
Format show spanningtree summary
Spanning Tree Adminmode
Enabled or disabled.