Intel BLADE SERVER IXM5414E - Manuale (Pagina 186)

Command Line Interface Management 163
Probe
Probe port, participating in Port Mirroring.
LAG Member of a LAG.
Admin Mode
Displays the administration mode of the port. The port must be enabled in order for
it to be allowed into the network. The factory default is enabled.
Physical Mode
Displays the port speed and duplex mode. If auto-negotiation is specified for the
port, then the duplex mode and speed will be set by the auto-negotiation process.
Note that the port's maximum capability (full duplex -100M) will be advertised. The
factory default is auto.
Physical Status
Indicates the port speed and duplex mode.
Link Status Indicates whether the link is up or down.
Link Trap Indicates whether or not a trap will be sent when link status changes. The factory
default is enabled.
LACP Mode Displays whether Link Aggregation Control Protocol is enabled or disabled on this
port.
FlowControl Mode
Displays whether flow control is enabled or disabled on this port.
Mirroring commands
config mirroring create
Use this command to configure a probe port and a mirrored port for port mirroring. The first port is
the probe port and the second port is the mirrored port. If this command is executed while port
mirroring is enabled, it will have the effect of changing the probe and mirrored port values. The
probe port will be removed from all VLANs.
Format config mirroring create <port> <port>
config mirroring delete
Use this command to remove the port mirroring designation from both the probe port and the
mirrored port. The probe port must be manually re-added to any desired VLANs.
Format config mirroring delete
config mirroring mode
Use this command to configure the port mirroring mode. The possible values are enable and disable.
The probe and mirrored ports must be configured before port mirroring can be enabled. If enabled,
the probe port will mirror all traffic received and transmitted on the physical mirrored port. It is not
necessary to disable port mirroring before modifying the probe and mirrored ports.
Default disable
Format config mirroring mode <enable/disable>