Intel BLADE SERVER IXM5414E - Manuale (Pagina 203)

180 Intel® Blade Server Ethernet Switch Module IXM5414E: Installation and User’s Guide:A Guide for Technically
logout
Use this command to close the current Telnet connection or reset the current serial connection. If you
have any saved configuration changes, you will be prompted to save them.
If you logout without issuing a save config command any configuration changes you have made will
be lost.
Format logout
ping
Use this command to have the switch transmit a Ping request to a specified IP address. This checks
whether the switch can communicate with a particular IP device. The switch will send three Ping
requests and display the results. The switch can be pinged from any IP workstation with which it is
connected through the default VLAN (VLAN 1), as long as there is a physical path between the
switch and the workstation.
Format ping <ipaddr>
reset system
Use this command to reset the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored configuration to
initialize the switch. You will be prompted to confirm that the reset should proceed. A successful
reset is indicated by the LEDs on the switch.
Format reset system
save config
Use this command to permanently save configuration changes made since the previous save or
reboot to Non-Volatile Random Access Memory (NVRAM). You are prompted to verify your
choice.
Format save config
show history
Use this command to show the contents of the command history buffer. The output will display the
oldest command in the history buffer first and the show history command (the newest command)
last.
Format show history
Transfer download commands
transfer download datatype
Use this command to configure the type of file to be downloaded to the switch.
Default code
Format transfer download datatype <code/config>