Intel BLADE SERVER IXM5414E - Manuale (Pagina 185)

162 Intel® Blade Server Ethernet Switch Module IXM5414E: Installation and User’s Guide:A Guide for Technically
Format config port autoneg <port/listofports/all> <enable/disable>
config port flowcontrol
Use this command to enable or disable IEEE 802.3x flow control for one or more ports.
Default disable
Format config port flowcontrol <port/listofports/all> <enable/disable>
config port lacpmode
Use this command to enable or disable the Link Aggregation Control Protocol (LACP) on one or
more ports.
Default disable
Format config port lacpmode <port/listofports/all> <enable/disable>
config port linktrap
Use this command to enable or disable link status traps for one or more ports.
✏ NOTE
This command is valid only when the Link Up/Down Flag is enabled (see “config trapflags
linkmode” on page 183).
Format config port linktrap <port/listofports/all> <enable/disable>
config port physicalmode
Use this command to configure the speed and duplex mode for one or more ports. For this
configuration to take effect, auto negotiation must be disabled.
Format config port physicalmode <port/listofports/all> <1000f/100f/100h/10f/10h>
Acceptable values are:
1000f 1000BASE-T full duplex
100f 100BASE-T full duplex
100h 100BASE-T half-duplex
10f 10BASE-T full duplex
10h 10BASE-T half duplex
show port
Use this command to display port information.
Format show port <port/listofports/all>
Port The interface number of the physical port or LAG whose information is displayed
on the line.
Type If not blank, this field indicates that this port is a special type of port. The possible
values are:
Mon Monitoring port, participating in Port Mirroring.