Intel BLADE SERVER IXM5414E - Manuale (Pagina 187)

164 Intel® Blade Server Ethernet Switch Module IXM5414E: Installation and User’s Guide:A Guide for Technically
show mirroring
Use this command to display the port mirroring information for the switch module.
Format show mirroring
Port Mirroring Mode
Indicates whether the port mirroring feature is enabled or disabled.
Probe Port The port that is configured as the probe port. If this value has not been configured,
‘Not Configured’ will be displayed.
Mirrored Port
The port that is configured as the mirrored port. If this value has not been
configured, ‘Not Configured’ will be displayed.
Simple Network Management Protocol (SNMP)
SNMP community commands
config snmpcommunity accessmode
Use this command to configure SNMP access to switch information for a specific community name.
The access mode can be Read-only (also called public) or Read/write (also called private).
Format config snmpcommunity accessmode <readonly/readwrite> <name>
config snmpcommunity create
Use this command to add (and name) a new SNMP community. A community name associates the
switch with a set of SNMP managers with a specified privileged level. The name can be up to 16
case-sensitive characters long.
Community names in the SNMP community table must be unique. If you make multiple entries
using the same community name, the first entry is kept and processed and all duplicate entries are
ignored.
Default There are two default community names: Public (with Read-only access) and
Private (with Read/write access). You can replace these default community names
with unique identifiers for each community. The default values for the remaining
four community names are blank.
Format config snmpcommunity create <name>
config snmpcommunity delete
Use this command to remove a name from the SNMP community table.
Format config snmpcommunity delete <name>
config snmpcommunity ipaddr
Use this command to specify the IP address (or portion thereof) from which this device will accept
SNMP packets with the associated community name. The requesting entity's IP address is ANDed
with the IP mask before being compared to this IP address. Note that if the IP mask is set to 0.0.0.0,
an IP address of 0.0.0.0 matches all IP addresses. The default value is “0.0.0.0”. The parameter
<name> is the applicable community name, and may be up to 16 alphanumeric characters.
Default 0.0.0.0