Vertex Standard VX-8R - Manual (Page 69)

VX-8R O
PERATING
M
ANUAL
67
M
EMORY
B
ANK
S
CAN
When the Memory Bank feature is engaged, the scanner sweeps only memory channels in
the current Memory Bank. However, if the Memory Bank Link Scan feature is enabled,
you may sweep the memory channels in several Memory Banks which you have selected.
To enable the Memory Bank Link Scan feature:
1. Set the radio to the Memory Recall (“MR”) mode by pressing the
key, if neces-
sary.
2. Press the key to activate the “Memory Bank” mode.
The “MR MR MR MR MR ” indicator will be replaced by one of the Memory
Bank numbers (“B 1 B 1 B 1 B 1 B 1 ” through “B24 B24 B24 B24 B24 ”).
3. Press the key followed by the key. The Memory
Bank number will begin to blink.
4. Rotate the DIAL knob to select the first Memory Bank
(“BANK 1 BANK 1 BANK 1 BANK 1 BANK 1 ” ~ “BANK24 BANK24 BANK24 BANK24 BANK24 ”) you wish to sweep using Memory
Bank Link Scan.
5. Press the key briefly. A “B-LINK ON B-LINK ON B-LINK ON B-LINK ON B-LINK ON ” notation will ap-
pear for two seconds on the display, indicating this Memory
Bank will now be swept during Memory Bank Scan.
6. Repeat steps 4 and 5 above, to append the “B-LINK ON B-LINK ON B-LINK ON B-LINK ON B-LINK ON ”
notation to any other Memory Banks you wish to sweep.
7. Press the key.
8. Now, press and hold in the key for one second to ini-
tiate the Memory Bank Link Scan.
9. To remove a Memory Bank from the Memory Bank Link Scan, repeat steps 1 - 5
above, to change the “B-LINK ON B-LINK ON B-LINK ON B-LINK ON B-LINK ON ” notation into “B-LINK OFF B-LINK OFF B-LINK OFF B-LINK OFF B-LINK OFF ”.
1) When the Memory Bank is enabled for Memory
Bank scan, the Memory Bank number (“B x”) in-
dication turns into “bx” (capital “B” turns into small
“b”).
2) You may enable/disable the Memory Bank scan via Set Mode
Item 7: BANK LINK.
M
EMORY
S
CANNING
S
CANNING
M
EMORY
B
ANK
S
CAN
“D
ISABLED
”
M
EMORY
B
ANK
S
CAN
“E
NABLED
”