FBT 37483_VAIE2550_manual1.pdf - Manuale (Pagina 94)

8-8
USING THE SYSTEM
UK
8.4.6 ZONE LISTS
Programming the groups of zones activated by a voice
source
Panel for setting the groups of the zones selected during the
announcement from a “voice” source that activates the Precedence or
VOX functions. It is possible to create up to 36 lists that occupy the six
zones of the VAIE 2250 unit to which the voice source is connected:
• Programming a zone list:
> Use the +/- knob to select the number of the list you wish to programme
(ZONE LISTS from 1 to 36). Refer only to the “VAIE 2250 ADDRESS:
1” unit.
> Activate or de-activate announcing in the zone concerned by pressing
and releasing the corresponding numbered key:
OFF = zone excluded
ON = zone active
8.4.7 DO NOT DISTURB
Disabling music and service announcements
Panel for setting the Do-Not-Disturb function for each output zone.
This function is operational only when the system is in the Quiescent
condition. It can be used to enable protection of the output zones to
stop music and service announcements being sent to it from the PA
sources.
The criterion for activation of this prevention is associated with the
priority of the PA Source involved. When a zone is in the “Do Not
Disturb” mode, the display referred to the MUSIC panel will show the
DND label on the status bar for that zone.
• Setting the DND function for each zone:
Hold the numerical key (1-6) associated with the zone to be programmed down and turn the +/- knob to select one of the following
modes:
• V+M: Do Not Disturb function disabled. The zone will broadcast music and announcements from all the PA sources.
• V>0:
The zone will broadcast only the announcements from all the PA sources. Music will not be broadcast.
• V>1: The zone will broadcast only announcements from the PA sources with priority levels from 2 to 7. Music will not be broadcast.
• V>2: The zone will broadcast only announcements from the PA sources with priority levels from 3 to 7. Music will not be broadcast.
• V>3: The zone will broadcast only announcements from the PA sources with priority levels from 4 to 7. Music will not be broadcast.
• V>4: The zone will broadcast only announcements from the PA sources with priority levels from 5 to 7. Music will not be broadcast.
• V>5: The zone will broadcast only announcements from the PA sources with priority levels from 6 to 7. Music will not be broadcast.
• V>6: The zone will broadcast only announcements from the PA sources with priority level 7. Music will not be broadcast.
• OFF: The zone is blocked for announcements from all PA sources up to priority level 7 and for music.
Only emergency messages and announcements broadcast by FMD 2001 and FMD 2012 emergency units can be broadcast.
Press ESC to return to the AUDIO SETTING menu.
The RESET, ALERT, EVAC, OK and MENU keys are not operational.
Note: The DND function is not affected by the programming of the paging zones associated with the PA source and has
priority over it. No feedback is sent to the PA Source to indicate that the zone is engaged. Thus, for example, a microphone
programmed for announcements to all zones will broadcast the call only to those zones that are enabled, while those for which
the DND function is active will remain mute.
Note: The current firmware version enables programming only for the six zones of the local VAIE 2250 unit. In a 12-zone
system, with two VAIE 2250 units connected to one another, it is not possible to relay the voice source activated via Precedence
or VOX to the remote unit. Thus, the Zone Lists referred to the “VAIE 2250 ADDRESS: 2” unit cannot be programmed.
Press ESC to return to the menu AUDIO SETTING.
The RESET, ALERT, EVAC and MENU keys are not operational.