FBT 37483_VAIE2550_manual1.pdf - Manuale (Pagina 104)

8-18
USING THE SYSTEM
UK
8.6 < OPERATOR > MENU
Panel for selecting options for which the personnel
instructed and authorised to manage the system in
emergency, failure and disablement conditions are
responsible.
The options of the OPERATOR menu enable the following management panels to be accessed:
8.6.1 CONTROL INPUTS panel (via the set > CONTROL INPUTS option)
For setting the eight input contacts of the VAIE 2250, in order to programme the events that activate a “Voice Alarm Condition”.
8.6.2 CONTROL OUTPUT panel (via the set > CONTROL OUTPUT option)
For programming the output contacts of the VAIE 2250, of which six open collector and 2 relay contacts, for connection to external
peripheral units, for the purpose of signalling diagnostics, operating conditions, overrides or remote activations.
8.6.3 BACKGROUND TEST panel (via the set > BACKGROUND TEST option)
For enabling and disabling monitoring of parts affecting the ability of the system to function in emergency conditions.
8.6.4 EMERGENCY UNITS (via the set > EMERGENCY UNITS option)
Dedicated section for FMD 2001 and FMD 2012 emergency units. This section enables the addresses to be acquired, the
parameters to be set and the keys to be configured.
8.6.5 DISABLEMENT panel (via the set > DISABLEMENT option)
For disabling, in one or more emergency zones, the activity envisaged for an “Alarm Condition” (Voice Alarm Condition). If at least
one zone is set to a “Disablement Condition”, the dedicated “DIS.” LED will signal the existence of a “Disablement Condition”.
8.6.6 FAULTS panel (via the report > FAULTS option)
Query concerning the status of current and cleared failures as described in the Section on INSPECTION. In addition, this level
enables MANUAL RESETTING OF FAILURE SIGNALS.
8.6.7 FIRMWARE VERSION panel (via the Firmware Version option)
This panel shows the version of the firmware installed in the system.
< INSPECTION >
For going directly to the INSPECTION menu, see point 8.5.
< CONFIGURATION >
For going directly to the CONFIGURATION menu, see point 8.7.
8.6.8 Exit > Logout option
To exit from the service level and return to the basic level, reinstating the access password.
If an access password was enabled during configuration, the
following panel will be shown: OPERATOR ACCESS
- Enter the 4-digit password and OK to proceed,
or
- press ESC to return to the MAIN page.
The default password is 2222.
Following access, from the OPERATOR menu, turn the knob to
browse through the options listed:
• set > CONTROL INPUTS
• set > CONTROL OUTPUT
• set > BACKGROUND TEST
• set > EMERGENCY UNITS
• set > DISABLEMENT
• report > FAULTS
• -> --
• -> --
• Firmware Version
< INSPECTION >
< CONFIGURATION >
• Exit > Logout
Select the required item by pressing OK, or
- press ESC to return to the MUSIC panel,
- press MENU to return to the MAIN page.