FBT 37483_VAIE2550_manual1.pdf - Manuale (Pagina 73)

5-4
CONNECTIONS AND SIZING
UK
5.3 LOCAL OUTPUT CONTACTS
Examples of connection of the control outputs with programming of the outputs for a quiescent condition: normally active and normally not
active. For details about programming the operating mode of the control outputs and the choice of activation events, refer to the section on
“set > CONTROL OUTPUT” (see point 8.6.2).
• Status of outputs with the system in a quiescent condition (output contacts not activated)
• Status of outputs with the system in an active condition (output contacts activated)
Relè A
Relè B
Relè F
Relè A
OUT 1
Normal state OFF
OUT 2
Normal state ON
OUT 6
Normal state ON
RELAY AUX 1
Normal state ON
RELAY AUX 2
Normal state OFF
Relè B
Relè F
Examples of settings of
output parameters in:
set > CONTROL OUTPUT
5.3.1 Local output contacts for a 12-zone system
The two VAIE 2250 units, connected to one another so as to form a 12-zone system, will activate their output contacts depending on the
individual status of each VAIE 2250 unit, regardless of that of the other unit. The output contacts (CONTROL OUTPUTS) from OUT1 to
OUT6 of one VAIE 2250 unit cannot be connected to the output contacts of a second VAIE 2250 unit. The RELAY 1 and RELAY 2 output
contacts of one VAIE 2250 unit can be connected to the RELAY 1 and RELAY 2 contacts of another VAIE 2250 unit, either in series or
in parallel, so as to group their activation. To programme the output contacts for each of the VAIE 2250 units, refer to the heading “set
> CONTROL OUTPUT” (point 8.6.2).
External peripheral unit External peripheral unit
External peripheral unit External peripheral unit