Campomatic C46VM - Manuale (Pagina 18)

The cycle proceeds automatically in the following order:
The evacuation phase is signalled by the light for the button blinking. The phase lasts
around three minutes.

During the following discharge phase all the lights go back to the initial start-up situation.
The discharge valve is open for 20 seconds.

At the end of the cycle, an acoustic signal is emitted (short Beep), which indicates
that the machine is ready for a new cycle. The basin appears decompressed enabling the
container to be extracted.
Note: The cycle can be interrupted early by pressing the button.
Close the container air-evacuation valve quickly, in order to avoid air coming back into the
container.
Note: The vacuum obtained by this cycle is around 100% of the vacuum which can be
reached with the SV46 and, consequently, is only indicated for very resistant and thick
plastic containers, or those made of glass or stainless steel.
Interrupting the cycle in progress
By pressing the button, an acoustic signal will warn you that the cycle will be immediately
interrupted. In this case, the device will not carry out the soldering and the chamber will be
decompressed. After the discharge phase all the lights go back to the initial start-up situation.
Wait around 20 seconds and for the acoustic signal before starting-up a new cycle.
18