Bird Technologies 6091P - Manuale (Pagina 4)

WARNING
Do not place compressed air near or directly against skin. Do not use compressed air in excess of 30 psi (207 kPa)
when cleaning or drying parts. Improper use of compressed air can cause serious injury or death.
WARNING
Coolant containing ethylene glycol is a potential health hazard. Avoid ingestion, inhaling of vapors and eye and skin
contact.
WARNING
Do not attempt to handle or move this unit alone. More than one person is needed to move this unit to avoid
possible injury.
Caution Statements
The following equipment cautions appear in the text whenever the equipment is in danger of damage, and
are repeated here for emphasis.
CAUTION
The Calorimeter can overheat if operated without sufficient coolant. Failure to keep coolant reservoir adequately filled
can result in serious damage to the equipment.
CAUTION
Use only premixed coolant Bird part number 6091-120. Use of other solutions will damage the instrument and void
all warranties.
CAUTION
Do not tighten the jack screws with a screwdriver. The screwdriver slots in the screw are provided for removal
purposes only.
CAUTION
During remote operation, periodically monitor the bus service request line. Failure to detect the service request can
result in major equipment damage.
CAUTION
The rack enclosure must provide at least 100 ft
3
/min of unrestricted air flow. Avoid mounting the Calorimeter above
instruments that give off heat. If necessary, isolate the Calorimeter from heat-generating devices with foam or
fiberglass.
CAUTION
The total length of all cables used must be less than the number of devices connected times 2 meters (6.6 feet).
Never exceed 20 meters of total length.
CAUTION
Only finger-tighten the GPIB connector screws. The screwdriver slots are provided for loosening and removal of
screws only. Connector screw threads may be stripped if tightened with a screwdriver.
CAUTION
Never turn off the Calorimeter’s main power switch while RF source power is applied to Calorimeter input. Failure
to turn off RF power source can result in major equipment damage.
CAUTION
Do not apply RF power to the load without proper coolant flow. Failure to keep coolant at proper flow rate can
result in serious damage to the equipment.
ii