Bird Technologies 6091P - Manuale (Pagina 19)

Chapter 3
Installation
This chapter contains information on site and shelter requirements, unpacking and
inspection, and preparing the Calorimeter for use.
Site and Shelter
Requirements
The Model 6091/6091P Calorimeter is designed for use in a laboratory environment.
The unit is not intended for outdoor use, or use in areas of condensing humidity. It
must be located near an ac power source.
WARNING
Do not attempt to handle or move this unit alone. More than one person is needed to move
this unit to avoid possible injury.
Unpacking and
Inspecting
1. Carefully inspect the Calorimeter shipping container for signs of
damage. If damage is noticed, do not unpack the unit. Immediately
notify the shipping carrier and Bird Electronics of the damage.
2. If the container is not damaged, unpack the unit. Save the shipping
materials for repackaging.
3. Check contents against the equipment list in Chapter 1. Inspect all
components for visual signs of damage. Immediately notify the ship-
ping carrier and Bird Electronic Corporation of equipment damage or
missing parts.
Setting the Voltage
Selector Switch
The Calorimeter can be operated at 104 to 132 volts RMS or 195 to 264 volts RMS.
The sensor unit is preset at the factory for 115 Vac operation. Verify voltage selection
and fuse rating; follow the steps below if a change is required.
1. Locate the power entry module, refer to figure 5, on the back of the Calorime-
ter unit.
7
100V-120V
200V-240V
100V-120V
WITH
250V
USE
ONL Y FUSES
Module
ON/OFF
Switch
Fuse
Fuse Voltage
Selector Card
Fuse Drawer
Figure 5
Power Entry
Module