Proel PLML575SEPS - Manuale (Pagina 31)

Dimmer
Dimmer 0-100%
Prisma
Prisma 3 facce rotante in entrambe le direzioni a velocità regolabile
Focus
Focus motorizzato
Effetti
16 macro: combinazioni tra prisma e gobos
Effetti pulsazione preprogrammati
Motori
14 motori passo passo controllati da un microprocessore
Elettronica
Ingresso digitale seriale DMX-512
16 canali di controllo (protocollo 16 bit completo)
canale 1 movimento orizzontale – 8 bit
canale 2 movimento orizzontale fine – 16 bit
canale 3 movimento verticale – 8 bit
canale 4 movimento verticale fine – 16 bit
canale 5 velocità del movimento di pan/tilt
canale 6 velocità delle ventole, accensione spegnimento delle lampade, reset
canale 7 ruota colori 1
canale 8 ruota colori 2
canale 9 prisma
canale 10 ruota gobo fissi
canale 11 ruota gobo rotanti
canale 12 rotogobo
canale 13 iris
canale 14 focus – multistep zoom
canale 15 shutter, strobe
canale 16 dimmer
Pan – Tilt
Movimento del pan con ampiezza massima di 530
°
Movimento del tilt con ampiezza massima di 280 °
31
OPERATING DETERMINATIONS
This device is a moving-head spot for creating decorative effects. This product is only
allowed to be operated with an alternating current of 230V - 50Hz (120V - 60Hz USA)
and was designed for indoor use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres
etc.
Lighting effects are not designed for permanent operation. Consistent operation breaks
will ensure that the device will serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or operating the device.
Do not switch-on the fixture without the lamp.
Never lift the fixture by holding it at the projector-head, as the mechanics may be
damaged. Always hold the fixture at the transport handles.
The minimum distance between light-output and the illuminated surface, must be more
than 1 meter.
When choosing the installation-spot, please make sure that the device is not exposed to
extreme heat, moisture or dust. There should not be any cables lying around. You
endanger your own and the safety of others!
Always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the correct
holes only.
Only operate the fixture after having checked that the housing is firmly closed and all
screws are tightly fastened.
The lamp must never be ignited if the objective-lens or any housing-cover is open, as
discharge lamps may emit a high ultraviolet radiation, which may cause burns.
The maximum ambient temperature (T
a = 40°C) must never be exceeded.
CAUTION: The lens has to be replaced when it is obviously damaged, so that its function
is impaired, e. g. due to cracks or deep scratches!
Operate the device only after having familiarized with its functions. Do not permit
operation by persons not qualified for operating the device. Most damages are the result
of unprofessional operation.
CAUTION: the lamp has to be replaced when it is damaged or deformed due to the heat!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to
safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
38