Videotec DCJ - Manuale (Pagina 200)

Page 68 MNVADCJ01_0543
6.5.4 Using the d ome
WARNING: : the zoom can be used in two modes: normal and slow (to allow greater precision). To enable slow
mode use the zoom keeping the 6 key pressed.
There are a number of shortcut controls that make it possible to enable the desired function without having to
insert the corresponding code. All of these controls are given as follows:
 enables the “Auto iris” function, showing the options on the screen. (corresponds to “OFF-90-ENTER”
followed by “ON-3-ENTER”).
enables the “Auto focus” function, showing the options on the screen. (corresponds to “OFF-90-ENTER”
followed by “ON-4-ENTER”).


enables the “Auto pivot” function, which enables an object to be followed, even when the dome reaches
the azimuth position. ( corresponds to “OFF-90-ENTER” followed by “ON-18-ENTER”).


enables the “Auto pan” function, passing cyclically between the two limit position settings. (corresponds to
“ON-2-ENTER”).


enables the “Preset Tour” function, passing cyclically between the various preset positions. (corresponds
to “ON-8-ENTER”).

+Num.+
 (Num.=1-99) enables the “Preset Save” function, saving the preset tour with the desired
number. (corresponds to “SET-XX-ENTER”).
 +Num.+
 (Num.=1-99) enables the “Preset Call” function by recalling the desired preset tour.
(corresponds to “SHOT-XX-ENTER”).