Pioneer VSX-415-S/-K - Manuale (Pagina 61)

Additional information 11
61
En
English
Français
Deutsch
Nederlands
Italiano
Español
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
VSX-415 model:
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press the TONE button.
OK? shows in the display.
4 Press TONE once more to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
VSX-515 model:
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press the ENTER button.
OK? shows in the display.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker
impedance
We recommend using speakers of 8 Ω with this
system, but it is possible to switch the imped-
ance setting if you plan to use speakers with a
6
Ω impedance rating.
• With the receiver in standby, press
STANDBY/ON while holding down the
SPEAKER IMPEDANCE button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6 Ω .
• SP 8 OHM – Use this setting if your
speakers are rated at 8 Ω or more.
VSX_415-515.fm 61 ページ ２００５年１月２１日 金曜日 午後５時３分