Pioneer VSX-415-S/-K - Manuale (Pagina 22)

Connecting up 04
22
En
Connecting the speakers (VSX-515)
A complete setup of eight speakers (including the subwoofer) is shown below, but everyone’s home
setup will vary. Simply connect the speakers you have in the manner shown below. The receiver will
work with just two stereo speakers (the front speakers in the diagram) but using at least three
speakers is recommended, and a complete setup is best for surround sound.
If you’re not using a
subwoofer, change the front speaker setting (see Speaker setting on page 48) to LARGE .
Make sure you connect the speaker on the right to the right terminal and the speaker on the left
to the left terminal. Also make sure the positive and negative (
+ / – ) terminals on the receiver match
those on the speakers. 1 You can use speakers with a nominal impedance between 6–16 Ω (please
see Switching the speaker impedance on page 61 if you plan to use speakers with an impedance of
less than 8 Ω ).
Be sure to complete all connections before connecting this unit to the AC power source.
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
Note
1 If you are using only one surround back speaker, connect the positive wire to the right channel ( + ) terminal, and the negative
wire to the left channel ( – ) terminal (see illustration).
COAX
COAX
OPT
(TV/SAT)
(DVD /LD)
(CD)
ASSIGNABLE DIGITAL IN
1
1
2
FRONT R L R L CENTER SURROUND R L SURROUND BACK
S I N G L E
S
P
E
A
K
E
R
S
SEE INSTRUCTION MANUAL
AM LOOP FM UNBAL 75 Ω
IN
IN
IN
MONITOR OUT
SUB WOOFER
SURROUND
CEN- TER
OUT
VIDEO
SUB WOOFER
R AUDIO L
IN
IN
IN
IN
OUT
OUT
IN
CD L R
DVR/ VCR
TV / SAT
DVD /LD
PLAY
CD-R / TAPE / MD
FRONT
PREOUT
REC
ANTENNA
DVD 5.1CH INPUT
D V D 5.1CH INPUT
INPUT
VSX-515
Front speakers
L R C LS RS
Powered subwoofer
SW
Single
surround
back
speaker
Surround speakers
SBL SBR
Surround back speakers Center speaker
1 2 3
10mm
VSX_415-515.fm 22 ページ ２００５年１月２１日 金曜日 午後５時３分