Pioneer VSX-415-S/-K - Manuale (Pagina 43)

Setting up the receiver 07
43
En
English
Français
Deutsch
Nederlands
Italiano
Español
Digital input settings
Here you tell the receiver what components
you have hooked up to the coaxial and optical
DIGITAL IN jacks on the back of the receiver.
After you assign a component to a digital jack,
whenever you select that component, (for
example, a DVD player) the receiver
automatically changes to the digital input
setting and
DIGITAL shows in the display.
• Use / (cursor up/down) to assign
components to the digital inputs.
For each input, select DVD , TV , CD , CDR , DVR
or OFF (default settings are listed below).
Remember to use / (cursor left/right) to
switch between the following inputs:
• Coaxial digital 1 – DVD
• Coaxial digital 2 – CD
• Optical digital 1 – TV
Setting separate channel levels
for listening modes
• Default setting: 0 dB
You can set relative channel levels from the
listening position using the method below.
Using
CH SELECT (see tip below), it is also
possible to set separate channel levels for each
of the listening modes. 1
1 Press STANDARD or ADVANCED
SURROUND . 2
2 Press TEST TONE to output the test tone.
The test tone is output in the following order
(depending on the speaker setting):
• If you don’t hear a test tone from one of
your speakers, please refer to Speaker
setting on page 41 to make sure you have
correctly specified your speaker setup.
3 Press VOLUME +/– to adjust the volume to
an appropriate level.
4 Use LEVEL +/– to adjust the speaker levels
in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
3
5 When you’re done, press TEST TONE to
turn off the test tone.
Tip
• The speaker volume can be adjusted
without outputting the test tone by
pressing
CH SELECT and then using LEVEL
+/– . However, you can only adjust the level
of the speakers currently active in the
mode you’re listening to. You can set sepa-
rate levels for the
STANDARD , STEREO
and DVD 5.1 ch modes, as well as for each
ADVANCED SURROUND mode.
Note
1 Using test tones to set up your speaker system will overwrite any previous settings you had for the STANDARD or ADVANCED
SURROUND modes.
2 Test tone is only output in STANDARD or ADVANCED SURROUND mode.
CD R/
TAPE/MD
MIDNIGHT/
LOUDNESS
ADVANCED
SURROUND STANDARD
TUNER
TOP MENU SETUP
STEREO
CD FM AM
MENU
CH SELECT
TEST TONE LEVEL
TUNER
CLASS
MPX DVD
EFFECT
MUTE
VOLUME
3 Since the subwoofer transmits an ultra-low frequency its sound may seem quieter than it actually is.
L C R
LS SW
RS
VSX_415-515.fm 43 ページ ２００５年１月２１日 金曜日 午後５時３分