Pioneer VSX-415-S/-K - Manuale (Pagina 50)

The System Setup menu 08
50
En
1 Select ‘ X.OVER’ from the SP SETUP menu.
2 Use / (cursor up/down) to choose the
frequency cutoff point.
Frequencies below the cutoff point will be sent
to the subwoofer (or
LARGE speakers).
3 When you’re finished, press RETURN.
Channel level
Using the channel level settings, you can
adjust the overall balance of your speaker
system, an important factor when setting up a
home theater system.
1 Select CH LEVEL from the SP SETUP menu.
2 Use / (cursor up/down) to select a
setup option.
• T. TONE M. – Move the test tone manually
from speaker to speaker and adjust
individual channel levels.
• T. TONE A. – Adjust channel levels as the
test tone moves from speaker to speaker
automatically.
3 Confirm your selected setup option.
The test tones will start after you press ENTER .
4 Adjust the level of each channel using the
/ (cursor up/down) buttons.
If you selected T. TONE M. , use / (cursor
left/right) to switch speakers.
The T. TONE A. setup will output test tones in
the following order (depending on the speaker
setting):
Adjust the level of each speaker as the test
tone is emitted. 1
5 When you’re finished, press RETURN.
Tip
• You can change the channel levels at any
time by using EFFECT/CH SEL and +/– on
the remote control. You can set two
channel levels: one for
DVD 5.1 CH and
one for the listening modes.
Speaker Distance
For good sound depth and separation from
your system, you need to specify the distance
of your speakers from the listening position.
The receiver can then add the proper delay
needed for effective surround sound.
1 Select ‘SP DISTN.’ from the SP SETUP
menu.
2 Use / (cursor left/right) to choose the
speaker that you want then set the distance.
Use / (cursor up/down) to adjust the
distance of each speaker (in 0.1 meter
increments).
3 When you’re finished, press RETURN.
Tip
• For best surround sound, make sure the
surround back speakers are the same
distance from the listening position.
Note
1 • If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level
of each speaker to 75 dB SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
L C
RS
R
LS SW SB
VSX_415-515.fm 50 ページ ２００５年１月２１日 金曜日 午後５時３分