Fulgor Milano SBQ 1000 G - Manuale (Pagina 92)

92 93
GB
Manual lighting
•
If the automatic ignition system is not working, the barbecue can be lit manually.
• To turn it on manually, use a long match (28cm). Temporarily remove the oil drip pan and
pass the lit match between the inspection slits under the front of the cooking plates, bringing
it close to the burner and then turn the knob to “MAX” (fast pre-heating) to light it. If it does
not light, close the control valve and wait a few minutes for the gas to disperse before trying
to light the barbecue again.
• Once one burner is lit, repeat the procedure for the others, if necessary.
Inspection slits
Pre-heating cooking areas
•
The barbecue is equipped with high-power burners. Under most conditions, it will only be
necessary to pre-heat the barbecue for just 5 minutes before starting to cook.
• As with most things, experience will teach the user the effectiveness and interval necessary
for reaching the best pre-heating time for obtaining the ideal cooking temperature. Don’t
forget that this also depends on the type of food, its thickness and how you want to cook it.
• Tests have shown that you can reduce the heat of the burners for satisfactory cooking.
• If the barbecue has a thin cover, you should remove it in the presence of wind.
• If the appliance is not working properly, refer to the chapter “Troubleshooting”.
• If you let the cooking areas overheat, there will be excessive smoke during cooking and the
food will burn.
• To roast with the high cover closed, it is sufficient to adjust the 4 burners to the minimum
power (MIN) for satisfactory cooking