Videotec DCJ - Manuale (Pagina 160)

Page 28 MNVADCJ01_0543
5.2.4.2 Requesting the views
Press a key from
*
to
)
to request the corresponding view.
5.2.4.3 Erasing the customised views
Press keys 6- simultaneously.
The default settings for the views can be used to recall cameras 1 to 9 directly without changing the active
monitor and without making scans. The * recalls camera 10.
5.2.5 Receivers a ssociated with the cameras
To each camera is associated a telemetry receiver.
It is possible for one receiver to be present for each camera and this receiver is assigned permanently at the
system installation stage. When the camera-receiver association has been defined it should never be changed
unless there are changes to the system itself.
The installation procedure normally expects the assignment of a receiver number corresponding to that of the
video input (for example, camera number 10 is controlled by receiver number 10), but the assignment may be
more flexible.
Every time a camera has been requested and following this selection a new receiver number is requested, this
receiver number will be “remembered” by the keyboard. If requesting a different receiver number from the pre-
assigned number is not to be allowed, we advise disabling the setup menu option:
**,37,+9(U8,6Q 81*7S216Q,*,S9P*/.
For example:
!
C
RPCx
R

Camera 1 has been requested. The display
shows that the receiver currently associated
with this camera is number 1.
%
C
RP!x
R

If the operator is authorised to do so, he can
assign another receiver number to the camera;
if not the display shows an error message.
"

RP x
R

Camera 2 has been requested, and the display
shows that it is currently associated with
receiver 2.
!
C
RP!x
R

Following the new request for camera 1 the last
receiver associated with camera 1 is shown.