Vertex Standard FT-1000MP - Manual (Page 33)

Page 31 O
PERATING
M
ANUAL
LCD B
ARGRAPH
M
ETER
I
NDICATIONS
TUNER
This indicator comes on when the automatic an-
tenna tuner (ATU) is activated and in-line.
WAIT
Appears when the ATU is seeking the best imped-
ance match with the antenna. It also flashes each time
the transceiver microprocessor sends frequency up-
date data to the ATU microprocessor (while you tune).
HI SWR
Appears when an abnormally high SWR condition
exists that cannot be matched below 3.0:1.
RX/CLAR/TX
These appear indicating the selected Clarifier func-
tion (Rx, Tx or both). The Clarifier offset frequency ±9.99
kHz) is shown in the sub-display immediately to the
right.
ANT A/B
Indicates the antenna selected for operation (A or
B) by the front panel ANT [A/B] switch (see item on
page 23).
CAT
External computer control of the transceiver is ac-
tive. This indicator may appear to “blink” periodically if
your software “polls” the transceiver every few seconds
(for example, to confirm the current operating fre-
quency).
CLEAR
Indicates the selected memory channel is not yet
filled with data.
OFFSET
When enabled, this field shows the frequency dif-
ference (split offset) between Main VFO-A and Sub
VFO-B.
Multi-Display Window
Displays either the Clarifier offset, memory chan-
nel frequency, split frequency offset, or CW pitch.
MEM F
Appears when the memory channel frequency ap-
pears in the multi-display panel.
GROUP
When the [M GRP] button is pressed, this indicates
that the “memory recall” mode is engaged, and that
scanning is limited to those memories in the currently-
selected group.
TRACK
Appears when the VFO Tracking feature is acti-
vated.
Memory Channel Box
During normal operation, the currently-selected
memory group and memory channel number appear
here. With the Menu Programming mode active, menu
selection numbers are displayed.
M CK
Appears when the Memory Check mode is acti-
vated.
LOCK
Appears when the Sub VFO tuning knob is dis-
abled (it still turns but does nothing).
Sub Receiver MODE
Displays the currently-selected operating mode for
the Sub receiver.
Sub Receiver S-Meter
Displays relative signal strength.
Sub Receiver Frequency Display
Displays the current sub-receiver frequency used
during dual receive operation, and the transmit fre-
quency during most split operation.
QMB MEM LSB USB CW AM FM RTTY PKT M TUNE RPT VFO
TUNER WAIT
CLAR
HI SWR
RX TX
OFFSET MEM F TRACK
ANT A B
GROUP CLEAR
CAT
CH
LOCK M CK
S
1 3 5 7 9 +20 +40 +60dB