Vertex Standard FT-1000MP - Manual (Page 115)

Page 113 O
PERATING
M
ANUAL
Installing Internal Accessories
M
AIN
R
ECEIVER
2
ND AND
3
RD
IF F
ILTERS
A total of 5 optional crystal IF filter units can be in-
stalled in addition to the factory-installed filters (see
the table). Contact your dealer for pricing, availability
and ordering. These filters include small boards with
connectors, so no soldering is necessary for their in-
stallation.
Important! After filter installation, front-panel se-
lection is not possible until individual filters are enabled
via menu programming (menus selection 5-0 ~ 5-8). Re-
fer to the Menu Programming chapter and enable the
optional filters after installing them.
Filter Installation
r Disconnect all cables from the transceiver.
r Referring to Figure 1, remove the carrying handle
and its two screws (
Ú
), then remove the four
screws (
ð
) on each side of the transceiver, and
the seven screws (
¢
) from the bottom of the trans-
ceiver, then lift off the bottom cover.
r Referring to Figure 2, remove the three screws ( Æ
)
along the top edge of the rear panel, then lift off the
top cover.
r On the underside of the transceiver chassis, locate
the IF UNIT. Referring to the drowing below, deter-
mine the location of the filter(s) you are installing.
r Position each filter so that its connectors are aligned
with the mounting pins on the board, and push it
into place, so the nylon mounting tabs “mushroom”
through the holes and lock the unit in place.
r Connect the speaker cable to the speaker on the
top cover, then replace the all covers and screws
(unless installing other options now). Refer to pages
101 and 102 of the Menu Programming chapter to
enable newly-installed filters.
S
UB
R
ECEIVER
CW N
ARROW
F
ILTER
The optional YF-115C Collins mechanical filter (500
Hz BW) is available for the 455-kHz Sub Receiver 3rd
IF for enhanced reception. Only top cover removal is
required for installation.
Installation
r Disconnect all cables from the transceiver.
r Referring to Figure 1, remove the carrying handle
and its two screws (
Ú
), then remove the four
screws (
ð
) on each side of the transceiver, and
the seven screws (
¢
) from the bottom of the trans-
ceiver, then lift off the bottom cover.
r Referring to Figure 2, remove the three screws ( Æ
)
along the top edge of the rear panel, then lift off the
top cover.
r Locate the SUB RX Unit on the right side of the set.
r Referring to the photograph on page 112, determine
the location of the Sub Rx filter you are installing.
r Position the filter so that its connectors are aligned
with the mounting pins on the board, and push it
into place, so the nylon mounting tabs “mushroom”
through the hole and lock the unit in place.
r Connect the speaker cable to the speaker on the
top cover, then replace the all covers and screws,
unless installing the YF-115C options now. Refer to
the Menu Programming chapter to enable the newly-
installed filter (menu selection 5-8).
Optional IF Filter Units
8.2 MHz 2nd IF 455 kHz 3rd IF
Yaesu P/N
YF-114SN
YF-114CN
–
B/W
2.0 kHz
250 Hz
–
Yaesu P/N
YF-110SN
YF-115C ø
YF-110CN
B/W
2.0 kHz
500 Hz
250 Hz
ø: Collins Mechanical Filter