AJA UDC - Manuale (Pagina 12)

12
Loss of Input: Determines what action is taken when input video is lost. These are
the choices:
Black (default): The output goes to black.
Freeze: The output freezes on the last good frame.
HDMI Tab Screen Provides user selection of the HDMI output modes. There is no DIP switch equivalent
for these controls. The setting is saved in nonvolatile memory in the module and used
for all subsequent operation.
Mini Config, HDMI Screen
HDMI Video Output: The HDMI video output always mirrors the SDI video output,
both in content and output format selection. Note: when the output format is set to
1080psf23.98 or 1080psf24 the HDMI output is disabled since HDMI does not have a
corresponding supported format.
Protocol: Selects whether the HDMI output uses DVI or HDMI protocols for sending
video to the destination device. These are the choices:
Auto: UDC automatically selects the output protocol based on getting the
attached HDMI device's EDID information. This is the recommended setting.
The selected protocol is shown to the right of the popup control.
HDMI: UDC uses HDMI protocols regardless of the attached device's EDID.
DVI: UDC uses DVI protocols regardless of the attached device's EDID. Because
DVI protocols do not support audio or HDMI InfoFrame ancillary data, select
this mode only if you know that the attached device requires it.
Color Space: Selects the HDMI output color space and depth. These are the choices:
Auto: UDC automatically selects the mode based on getting the attached
HDMI device's EDID information. This is the recommended setting. The
selected mode is shown to the right of the pull-down control.
RGB 8Bit: UDC uses 8-bit RGB mode regardless of the attached device's EDID.
RGB 10Bit: UDC uses 10-bit RGB mode regardless of the attached device's EDID.
YCbCr 10Bit: UDC uses 10-bit YCbCr mode regardless of the attached device's EDID.