Vertex Standard PS1000 - Manual (Page 45)

Page 45 Phantom PS1000
3 Select type of reply function “ SEND ” or “ NO REPLY ”
by using the [ ] or [ ] key.
4. W h e n “ S E N D ” i s s e l e c t e d , p r e s s t h e
[CALL(SET)MENU] key. And your position will be
transmitted to the requesting vessel.
5. To exit from position request display, press the [16/9] key.
11.9 POSITION SEND
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the Phantom PS1000 to send the position.
11.9.1 Setting up a Position Send Ringer
The PS1000 has the capability to turn off the Position Send ringer.
1. Press and hold down the [CALL(SET)MENU] key
until “ RADIO SETUP ” menu appears.
2. Press the [ ] key to select “ DCS SETUP ” menu,
then press the [CALL(SET)MENU] key.
3. Press the [ ] or [ ] key to select “ DSC BEEP ” menu,
then press the [CALL(SET)MENU] key.
4. Press the [ ] or [ ] key to select “ POS SEND ”
menu, then press the [CALL(SET)MENU] key.
5. Press the [ ] or [ ] key to select “ oF .”
6. Press the [CALL(SET)MENU] key to store the se-
lected setting.
7. To exit this menu and return to radio operation mode
press the [16/9] key.
If you wish to return to enabling the ringer tone, just repeat the above proce-
dure, pressing the [
] or [ ] key to select “ on ” in step “5” above.
11.9.2 Transmitting a DSC Position Send Call
1. Press the [CALL(SET)MENU] key. The DSC Op-
eration menu will appear.
2. Press the [ ] or [ ] key to select “ POS SEND ” menu,
then press the [CALL(SET)MENU] key. The trans-
ceiver will beep, and the “Position Send directory”
will appear. (To cancel, press the [16/9] key)
3. Press the [ ] or [ ] key to select the “name” you
want to contact.
4. Press the [CALL(SET)MENU] key to send your position
to the selected vessel.