Vertex Standard PS1000 - Manual (Page 21)

Page 21 Phantom PS1000
KEY PAD
[SCAN] Key
Starts and stops scanning of programmed channels.
If held while the [
] or [ ] key is pressed, the radio will show the
channels programmed in scan memory. This function will not work if
the unit is scanning.
NOTE: The priority channel is Channel 16 only.
Secondary use
Press and hold the [SCAN] key to program the current channel into the
Scan Memory.
[CALL(SET)MENU] Key
The [CALL(SET)MENU] key functions as the enter key.
Secondary use
Press the [CALL(SET)MENU] key to access the DSC OPERATION menu.
The “INDIVIDUAL CALL,” “GROUP CALL,” “ALL SHIP CALL,” “POSI-
TION REQUEST,” and “POSITION SEND” functions can be accessed
from the DSC OPERATION menu.
Press and hold the [CALL(SET)MENU] key to access the RADIO SETUP
(refer ro section “8. ) or DSC SETUP menu (refer ro section 7).
[DW(IC)] Key
Watches for a transmission on CH16 and another selected channel until
either signal is received. (Dual watch)
NOTE: When the DSC SCANNING feature is enabled (see section “7.2
DSC SCAN”), the radio watches for a transmission on CH16, another
selected channel, and CH70 until either signal is received (Triple watch).
[NAV] Key
Press the [NAV] key, when connected to the GPS receiver, the LCD dis-
plays Position Information or Cruise Information from the GPS.
[WX] Key
Immediately recalls the previously selected US NOAA weather channel
from any channel location.
Secondary use
Holding down the [16/9] key while pressing the [WX] key switch the Chan-
nel Group.
[DISTRESS] KEY
Used to send a DSC Distress Call. To send the distress call refer to section
“11.4.1. Transmitting a DSC Distress Call.”