Pioneer DV-LX50 - Manuale (Pagina 12)

02
12
En
Switching the video output to 576i/480i using the front
panel controls
Switch the player to standby then, using the front panel controls,
press
 STANDBY/ON while pressing   to switch the player
back to 576i/480i.
• If the player is connected using HDMI, disconnect the HDMI
cable before resetting the player to 576i/480i output. (If left
connected, the HDMI output resolution will be reset to its
default — see Resetting the output resolution to the default
setting with HDMI connection on page 15.)
Connecting to an AV receiver
You can connect this player to your AV receiver using the
multichannel analog outputs or one of the digital outputs.
In addition to these connections, you should also connect the 2
channel analog outputs for compatibility with all discs.
You’ll probably also want to connect a video output to your AV
receiver. You can use any of the video outputs available on this
player (the illustration shows a standard (composite) connection).
1 Connect the analog AUDIO OUT (2ch) and VIDEO OUT jacks
on this player to a set of analog audio and video inputs on your
AV receiver.
2 Connect the AV receiver’s video output to a video input on
your TV.
You can also use the SCART AV connector, the S-Video or
component video jacks to connect to the AV receiver if you prefer.
Tip
• You usually have to connect the same kind of video cable
between your DVD player and AV receiver, and between your AV
receiver and TV.
Connecting the multichannel analog outputs
If your AV receiver has 5.1 channel analog inputs, we recommend
connecting this player to it using the multichannel analog outputs.
Doing this will ensure that you can enjoy all kinds of disc, including
Dolby Digital and DTS DVD-Video discs, as well as high sampling
rate and multichannel DVD-Audio and SACD discs.
• Connect the multi-channel audio outputs on this player to
the multi-channel audio inputs on your AV receiver.
It’s convenient to use three stereo audio cables; one for the
FRONT,
one for the SURROUND and one for the CENTER and SUBWOOFER
channels.
You can also use the SCART AV connector, the S-Video or
component video jacks to connect to the AV receiver if you prefer.
Tip
• After connecting up and switching on, you should change the
Audio Output Mode setting (page 36) in the Initial Setup menu
from the default
2 Channel to 5.1 Channel.
AV receiver
To audio inputs
To video inputs
To multi-channel audio inputs
AV receiver
DVLX50_WY_EN.book 12 ページ ２００７年８月３０日 木曜日 午後３時１０分