Pioneer VSX-817-K - Manuale (Pagina 51)

Additional information 11
51
En
English
Français
Deutsch
Nederlands
Italiano
Español
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the  STANDBY/ON button
for about three seconds.
3 When you see RESET? appear in the
display, press the ENTER button.
OK? shows in the display.
4 Press SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this
system, but it is possible to switch the imped-
ance setting if you plan to use speakers with a
6
Ω impedance rating.
• With the receiver in standby, press 
STANDBY/ON while holding down the
QUICK SETUP (VSX-417) / SPEAKERS (VSX-817)
button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6
Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8
Ω or more.
Power cord caution
Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or an electric
shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it
with other cords. The power cords should be
routed such that they are not likely to be
stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the
power cord once in a while. When you find it
damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement.
VSX-817 model only – USB
mass storage device is not
recognized by the receiver. • Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this
receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and
HFS are not supported).
• USB devices with an internal USB hub are not supported.
VSX-817 model only – USB
ERR3 shows in the display
when connecting a USB
device.
• If this message continues to appear after going through all the
checks in Important on page 45 of USB playback, take the unit to your
nearest Pioneer authorized service center or your dealer for servicing.
VSX-817 model only – Can’t
play audio files. • The WMA or MPEG-4 AAC files were recorded using DRM (digital
rights management), or the bit rate/sampling rate is not compatible
(see Compressed audio compatibility on page 46). This is not a
malfunction.
Problem Remedy
VSX417_817.fm Page 51 Wednesday, December 20, 2006 2:35 PM