Pioneer VSX-817-K - Manuale (Pagina 50)

Additional information 11
50
En
VSX-817 model only – No sound
from surround back speakers. • Refer to Speaker setting on page 37 to check the surround back
speaker settings.
• Refer to Channel level on page 38 to check the speaker levels.
• Refer to Using surround back channel processing on page 29 to
make sure surround back processing and the sound mode are set for
surround back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 37 to
YES
or PLUS.
• Switch the LFE Attenuator Setup on page 40 to LFEATT 0 or
LFEATT 10 .
The PHASE CONTROL
feature doesn’t seem to have
an audible effect.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a
PHASE setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see Speaker Distance on page 39).
Noise during playback of a
cassette deck. • Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back. • Set the digital volume level of the player to full, or to the neutral
position.
During a playback search,
noise is output from a DTS
compatible CD player. • This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control. • Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press DIMMER on the remote repeatedly to return to the default.
Problem Remedy
VSX417_817.fm Page 50 Wednesday, December 20, 2006 2:35 PM