The system setup menu 06 – Pioneer VSX-817-K Manuale d'uso

Pagina 36

Advertising
background image

The System Setup menu

06

36

En

1

Select ‘EQ A. SET’ from the Manual

MCACC setup menu.

• Make sure the microphone is connected.

• If you’re using a subwoofer, it is

automatically detected every time you
switch on the system. Make sure it is on
and the volume is at the middle position.

• See Other problems during Auto MCACC on

page 9 for notes regarding high
background noise levels and other possible
interference.

2

Wait for the EQ Auto Setup to finish.

As the receiver outputs test tones, the
frequency balance is adjusted automatically
for the following settings:

A. CH All Channel Adjust is a ‘flat’ setting
where all the speakers are set individually
so no special weighting is given to any one
channel.

F.ALG Front Align Adjust balances the
overall sound so that all speakers are set in
accordance with the front speaker settings
(no equalization is applied to the front left
and right channels).

You will return to the Acoustic Cal EQ setup
menu after the Acoustic Calibration
Equalization is set.

Copying your Acoustic Calibration EQ
settings

If you want to manually adjust the Acoustic
Calibration EQ (see Setting the Acoustic
Calibration EQ manually
below), we
recommend copying the

A. CH or the F.ALG

settings from the

EQ A. SET setup above (or

from Automatically setting up for surround
sound (MCACC)
on page 8) to one of the
custom (

C1 or C2) settings. Instead of just a flat

EQ curve, this will give you a reference point
from which to start.

1

Select ‘EQ COPY’ from the Manual MCACC

setup menu.

2

Use

/ to select C1 or C2 then use the

/ buttons to select the setting you want
to copy.

• You can also copy from one custom setting

to another. For more on the

A. CH and

F.ALG settings, see Setting the Acoustic
Calibration EQ automatically
above.

3

Use

/ to select ‘COPY? YES’ to copy

and confirm.
You can also use

/ to select COPY? NO to

cancel.

Setting the Acoustic Calibration EQ
manually

Before manually adjusting the Acoustic
Calibration EQ, we recommend copying the

A.

CH or the F.ALG settings from the auto setup
above (or from Automatically setting up for
surround sound (MCACC)
on page 8) to one of
the custom settings. Instead of just a flat EQ
curve, this will give you a reference point from
which to start (see Copying your Acoustic
Calibration EQ settings
above for how to do
this).

1

Select ‘C1 ADJ’ or ‘C2 ADJ’ from the

Manual MCACC setup menu.

2

Use

/ and ENTER to select which

method you want to use to adjust the overall
frequency balance.
It is best to choose whichever one you copied
to the custom setting in Copying your Acoustic
Calibration EQ settings
above.

A. CH ADJ – All the speakers can be set
independently so no special weighting is
given to any one channel. When adjusting,
test tones will sound for each individual
channel.

F.ALG ADJ – Speakers are set in
accordance with the front speaker
settings. The sound of the test tone will
alternate between the left front (reference)
speaker and the target speaker.

VSX417_817.fm Page 36 Wednesday, December 20, 2006 2:35 PM

Advertising
Questo manuale è associato alle seguenti prodotti: