VDO Z2 - Manual (Page 23)

14
EN
ensure that the electrodes of the pulse transmitter belt are wet, or that
the distance between the magnets and the speed/cadence transmitter
is not greater than 5 mm.
ATTENTION: Your computer can save the codes of up to 5 transmitters
1. Speed transmitter of bike 1
2. Speed transmitter of bike 2
3. Cadence transmitter of bike 1 (optional)
4. Cadence transmitter of bike 2 (optional)
5. Pulse transmitter
3.3.1. INITIAL OPERATION - PULSE TRANSMITTER
Put the pulse transmitter belt on and moisten the electrodes
(chapter 2.3)
3sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ Select DIG CONNECT SET
‚ Display DIG CONNECT
∂ ƒ Select PULSE SEARCH
‚ PULSE PAIRING
PAIR DONE appears in the display after several seconds if the pulse
transmitter was found. Automatic return to the TRIP DIST menu. If the
pulse transmitter was not found PULSE REPEAT appears. Use ‚ to
repeat the pairing process for the pulse transmitter. For troubleshooting
see chapter 15.
3.3.2. INITIAL OPERATION - SPEED TRANSMITTER
3sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ Select DIG CONNECT SET
‚ Display DIG CONNECT
∂ ƒ Select SPEED SEARCH
‚ SPEED PAIRING
Now turn the front wheel (both magnet and transmitter must be already
mounted)
PAIR DONE appears in the display after several seconds if the speed
transmitter was found. Automatic return to the TRIP DIST menu
SPEED REPEAT appears if the speed transmitter was not found.
Use ‚ to repeat the pairing process for the speed transmitter.
For troubleshooting see chapter 15.
3.3.3. INITIAL OPERATION - CADENCE TRANSMITTER (OPTIONAL
EXTENSION see chapter 1.5)
3sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ Select DIG CONNECT SET
‚ Display DIG CONNECT
∂ ƒ Select CADENCE SEARCH
‚ CADENCE PAIRING
Now turn the crank (magnet and transmitter must be already mounted)
PAIR DONE appears in the display after several seconds if the cadence
transmitter was found.
Automatic return to the TRIP DIST menu
If the cadence transmitter was not found CADENCE REPEAT will be
displayed. With ‚ repeat the pairing for the cadence transmitter
For troubleshooting see chapter 15.