Vertex Standard FT-2800M - Manual (Page 49)

47 FT-2800M O
PERATING
M
ANUAL
In some instances of erratic or unpredictable operation, the cause may be corruption of data
in the microprocessor (due to static electricity, etc.). If this happens, resetting of the micro-
processor may restore normal operation. Note that all memories will be erased if you do a
complete microprocessor reset, as described below.
M
ICROPROCESSOR
R
ESETTING
To clear all memories and other settings to factory defaults:
1. Turn the radio off.
2. Press and hold in the [MHz(SET)], [REV(DW)], [LOW(A/N)] and [D/MR(MW)] keys
while turning the radio on. The “MASRST” notation will appear on the display.
3. Press the [D/MR(MW)] key momentarily to reset all settings to their factory defaults
(press any other key to cancel the Reset procedure).
S
ET
M
ODE
R
ESETTING
To reset the Set (Menu) mode settings to their factory defaults, while leaving other settings
unchanged:
1. Turn the radio off.
2. Press and hold in the [REV(DW)], [LOW(A/N)] and [D/MR(MW)] keys while turning
the radio on. The “SETRST” notation will appear on the display.
3. Press the [D/MR(MW)] key momentarily to reset the Set (Menu) mode settings to their
factory defaults (press any other key to cancel the Reset procedure).
R
ESET
P
ROCEDURE