Vertex Standard FT-2800M - Manual (Page 33)

31 FT-2800M O
PERATING
M
ANUAL
M
EMORY
O
PERATION
M
EMORY
R
ECALL
Once you have stored the memory or memories desired, you must now switch from the
“VFO” mode to the “Memory Recall” mode, so you can operate on the just-stored memory
channels.
1. Press the [D/MR(MW)] key, repeatedly if necessary, until the “MR” icon and a memory
channel number appear on the display; this indi-
cates that the “Memory Recall” mode is now en-
gaged.
2. When more than one memory has been stored, use
the DIAL knob to select any pf the programmed memories for operation. Alternatively,
the microphone’s [UP] or [DWN] button may be used to step or scan through the avail-
able memories. When using the microphone’s buttons, press the button momentarily to
move one step up or down; press and hold in the [UP] or [DWN] button for one second
to begin memory scanning.
Memory Recall from the Microphone’s Keypad:
While operating in the Memory Recall mode, the keypad of the MH-48
A6J
Microphone may
be used for direct recall of memory channels.
To do this, press the Channel Number you wish to recall, then press the [Û] key. For ex-
ample, to recall Memory Channel “5,” press [5] а [Ы]. To recall Memory Channel “118,”
press [1] а [1] а [8] а [Ы].
Labeling Memories
You may wish to append an alpha-numeric “Tag” (label) to a memory or memories, to aid in
recollection of the channel’s use (such as club name, etc.). This is easily accomplished using
the Set (Menu) mode.
1. Recall the memory channel on which you wish to append a label.
2. Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to
select “00 ALPH.”
3. Press the [MHz(SET)] key. You will notice the first character location blinking, indicat-
ing that you are now in the Alpha-Numeric (“A/N”) entry mode. Within the A/N entry
mode, rotate the DIAL knob to select characters; pressing the [REV(DW)] key will
move the character’s entry location to the right.
4. Rotate the DIAL knob to select the desired number, letter, or symbol, then press the [D/
MR(MW)] key to move the next character’s location. Move two slots if you want to put
in a space.
5. Repeat step 4, as necessary, to complete the name tag (up to six characters) for your
memory, then press the [MHz(SET)] key momentarily to save the A/N name just entered.
6. Press and hold in the [MHz(SET)] key for one second to exit to normal operation.