Vertex Standard TRANSCEIVER VX-1700 - Manual (Page 36)

36
GPS POSITION REQUEST
This parameter determines whether the radio is
able to receive or transmit a GPS position request.
The available selections are “RX,” “TX,”
“TX+RX,” and “OFF.”
RX: Enables the receiving of a GPS posi-
tion request and disable the sending
of a GPS position request.
TX: Enables the sending of a GPS posi-
tion request and disables the receiv-
ing of a GPS position request.
TX+RX: Enables both the receiving and send-
ing of a GPS position request.
OFF: Disables both the receiving and
sending of a GPS position request.
: Requires the after-market GPS receiver for
transmitting your GPS position.
GPS POSITION SEND
This parameter determines whether the radio is
able to receive or transmit your GPS position.
The available selections are “RX,” “TX,”
“TX+RX,” and “OFF.”
RX: Enables the receiving a GPS position
send command and disables the
sending of your GPS position.
TX: Enables the sending of your GPS
position and disables the receiving
of a GPS position send command.
TX+RX: Enables the receiving and sending of
a GPS position.
OFF: Disables both the receiving and
sending of a GPS position.
: Requires the after-market GPS receiver for
transmitting your GPS position.
PREAMBLE
This parameter sets the preamble time for a Sel-
call.
The radio will transmit just a carrier signal (with-
out the data) for this “Preamble” period.
The available selections are “1 sec” to “16 sec.”
OFFSET TIME
This parameter sets the offset time between the
Local time and UTC time.
RADIO ID
This parameter programs the transceiver’s Alpha/
Numeric self-identification for the KILL and
STUN systems.
To enter the Alpha/Numeric self-identification,
double click the left mouse button on the desired
column, type the characters of the desired Alpha/
Numeric self-identification (up to 58 characters),
then press the [ENTER] key to save the pro-
grammed self identification.
MESSAGE
This parameter programs the Alpha/Numeric
messages for the Selcall feature.
To enter the Alpha/Numeric message, double
click the left mouse button on the desired column,
type in the characters of the desired Alpha/Nu-
meric message (up to 64 characters), then press
the [ENTER] key to save the programmed mes-
sages.
This parameter is also used to remote control the
VX-1700 using the “KILL,” “STUN,” and “RE-
VIVE” feature.
If the “CILLIK” command with the “Radio ID
(example: TEST6111)” is entered in this parame-
ter (total message is “CILLIKTEST6111”), the VX-
1700 which has the “TEST6111” radio ID will be
“killed” when this message is received.
Similarly, if the “ECNUTS” command with the
“Radio ID (example: TEST6111)” is entered in this
parameter (total message is “ECNUTST-
E S T 6 1 1 1 ” ) , t h e V X - 1 7 0 0 w h i c h h a s t h e
“TEST6111" radio ID will be “stunned” (disabled,
but capable of field revival) when this message
is received.
To revive the stunned VX-1700, send the “SVIV-
ER” command with the “Radio ID” (in this ex-
ample, TEST6111) (total message is “SVIVERT-
EST6111”).
Note: A “killed” VX-1700 cannot be revived by a
remote control command. To revive a killed VX-
1700, the channel setup cloning process must be
performed again.
Kill Command: CILLIK
Stun Command: ECNUTS
Revive Command: SVIVER
CE77 PC Programming Software