Vertex Standard TRANSCEIVER VX-1700 - Manual (Page 10)

10
Connector Pinout Diagrams / Slide Switch Setting
+13.8 V OUT
TX GND
GND
BAND DATA A
TX-INH
EXT ALC Input
TX REQ
BAND DATA B
BAND DATA C
BAND DATA D
MIC Jack GPS Jack
ACC Jack TUNE Jack DATA Jack
(As Viewed From Rear Panel) (As Viewed From Rear Panel) (As Viewed From Rear Panel)
(As Viewed From Rear Panel) (As Viewed From Front Panel)
P ENB
CNTL GND
PTT
MIC
MIC GND
UP
DOWN
+ 5V
Max. 1 A
This terminal is connected
in parallel with the pin 1 of
TUNE Jack.
Open Collector
(Max. 60 V, 1A)
This terminal is connected
in parallel with the pin 2 of
TUNE Jack. +13.8 V
TX GND
Pin 1
Pin 2
Max. 1 A
This terminal is connected
in parallel with the pin 1 of
ACC Jack.
Open Collector
(Max. 60 V, 1A)
This terminal is connected
in parallel with the pin 2 of
ACC Jack. +13.8 V
TX GND
Pin 1
Pin 2
Open Circuit Voltage: 5 V, Closed Circuit Current: 1 mA PTT Pin 3
60 mVp-p @1 k Ω.
500 mVp-p @1 k Ω
SQL OPEN: 5 V
SQL CLOSE: 0 V
DATA IN
DATA OUT
SQL OUT Pin 1
Pin 5
Pin 6
Connected with , , , and .
GPS Data Input (+)
N/C
Connected with , , , and .
Connected with , , , and .
Connected with , , , and .
Connected with , , , and .
NC
GPS Data Input (--)
DATA IN
GND
DATA PTT
DCD
DATA OUT
SQL OUT
ON: Disables the Memory Channel Storage from the transceiver.
OFF: Enables the Memory Channel Storage from the transceiver.
ON: Enables the ITU Memory Channel Operation.
OFF: Disables the ITU Memory Channel Operation.
This switch should always be set to "OFF."
This switch should always be set to "OFF." Memory Channel Storage
ITU Memory Channel
---
---
Switch 1
Switch 2
Switch 3
Switch 4
Slide Switch (Located on the MAIN Unit)
Accessory Port (Located on the MAIN Unit)
+13.8 V OUT
TX GND
GND
RX D
TX D
RESET
TX-INH
TUNER SENSE
ENCR_TXIN
ENCR_RXIN
INDICATOR
CODE (8)
ENCR_RXOUT
CLEAR/SCRAMBLE
PTT
VCC
GND
ENCR_TXOUT
CODE (4)
CODE (2)
CODE (1)