Vertex Standard TRANSCEIVER VX-1700 - Manual (Page 22)

22
CE77 PC Programming Software
MODE
This column selects the Operating Mode.
To select the Operating Mode, double click the left
mouse button on this column to invoke a pop-up
window, select the desired Operating Mode, then
click the [OK] button to accept the new Operating
Mode.
The available selections are “J3E (USB),” “J3E (LSB),”
“J2B,” “A1A,” and “A3E.”
FILTER
This column selects the bandwidth of the IF filter.
To select the bandwidth, double click the left mouse
button on this column to toggle the desired band-
width between “Wide (W): 2.2 kHz.” and “Narrow
(N): 600 Hz.”
This column does not function when the “VFO
MODE” parameter has been set to “J3E” or “A3E.”
CLAR VALUE
This column allows entry of the Clarifier Offset Fre-
quency.
To enter the Offset Frequency, double click the left
mouse button on this column, enter the desired Off-
set Frequency from the keyboard, then press the
[ENTER] key to accept the new frequency.
If an incorrect entry is made, the software will round
off the entry to the nearest valid frequency automat-
ically. Available values are “-1.00” to “+1.00” (kHz).
PWR
This column selects the Transmit Output Power.
To select the TX power, double click the left mouse
button on this column, then select the desired TX
power from among “Low,” “Mid,” and “High.”
SHIFT
This column may used to move a spurious response
“Birdie” from the CPU clock away from the operat-
ing frequency, should it cause interference.
To program this column, double click the left mouse
button on this column, then select the desired shift
value from among “1,” “2,” “3,” and “Off (-).”
ENCRYPTION ENCR
This column turns the Voice Encryption feature “on
(v)” or “off (-).”
To select this feature, double click the left mouse
button on this column, then set the Voice Encryp-
tion feature “on (v)” or “off (-).”
This column will not function in the software when
the Encryption Unit has been activated (determined
from the “Encryption Unit” parameter on the “Op-
tion” tab in the “Common” Menu), or if the option-
al Encryption Unit is not installed.
ENCRYPTION CODE
This column selects the desired Encryption code.
To program this column, double click the left mouse
button on this column to invoke a pop-up window,
select the desired Encryption code, then click the
[OK] button to lock in the new Encryption code.
SELCALL SELF ID
This column programs the 4-digit ID for your trans-
ceiver, utilized when using the SELCALL feature.
To enter the 4-digit ID, double click the left mouse
button on this column, enter the desired 4-digit ID
code (numeric only) from the keyboard, then press
the [ENTER] key to accept the new ID code.