Patents, Compliance, Laser safety – Datalogic Scanning DS4800 Manuale d'uso

Pagina 18: Power supply, Ce compliance

Advertising
background image

DS4800 QUICK GUIDE

18

PATENTS


This product is covered by one or more of the following patents:

U.S. patents 5,992,740; 6,394,352 B1; 6,742,710 B2; 6,688,524 B1

European patents 789,315 B1; 959,426 B9

Additional patents pending.

COMPLIANCE

LASER SAFETY

The scanner is classified as a Class 2 laser product according to
EN 60825-1 regulations and as a Class II laser product according
to CDRH regulations.

Disconnect the power supply when opening the device during
maintenance or installation to avoid exposure to hazardous laser
light.

There is a safety device, which allows the laser to be switched on
only if the motor is rotating above the threshold for its correct
scanning speed.

The laser beam can be switched off through a software command
(see also the Genius Help On Line).

The laser diode used in this device is classified as a class 3B laser
product according to EN 60825-1 regulations and as a Class IIIb
laser product according to CDRH regulations.

Any violation of the optic parts in particular can cause radiation up
to the maximum level of the laser diode (40 mW at 630 to 680 nm).

AVOID EXPOSURE

LASER LIGHT IS EMITTED

FROM THIS APERTURE

CAUTION-CLASS 3B

LASER LIGHT WHEN OPEN

AVOID EXPOSURE TO BEAM

This product conforms to the

applicable requirements

of 21CFR1040 at the date

of manufacture

LASER LIGHT

DO NOT STARE INTO BEAM

CLASS 2 LASER PRODUCT

MAX. OUTPUT RADIATION 1 mW

EMITTED WAVE LENGTH 630~680 nm

TO EN 60825-1:2001

U.S. pat. 5,992,740; 6,394,352B1; 6,742,710B2; 6,688,524B1.

EP pat. 789,315B1; 959,426B9

DATALOGIC AUTOMATION S.r.l.

Via S. Vitalino, 13 – 40012 Calderara di Reno

MADE IN ITALY-www.datalogic.com

Figure 13 - Warning and Device Class Labels


POWER SUPPLY


This product is intended to be installed by Qualified Personnel only.

This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit with «Class 2» or
LPS power source, which supplies power directly to the scanner via the 25-pin connector.

CE COMPLIANCE


Warning: This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.




821001470 (Rev. A)

Advertising