Pioneer VSX-D714 - Manuale (Pagina 11)

5 minute guide 02
11
En
English
Italiano
Français
Nederlands
Español
Deutsch
Using the Quick Setup
You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
Note that with the VSX-D814 you don’t have to
make these settings if you use the automatic
MCACC setup instead (in this case, go
straight to the
Quick surround sound setup on
page 13).
If you want to make more specific settings,
refer to
Choosing your receiver setup on
page 41.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
SW DET flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
* VSX-D814 only
If a subwoofer wasn’t detected in step 2, you
can cycle between the following choices:
* VSX-D814 only
• Check the table below to find the speaker
setup that corresponds with your system.
* VSX-D814 only
UP DOWN
MULTI JOG
MASTER VOLUME
ENTER
SPEAKERS
S-VIDEO DIGITAL IN SETUP MIC VIDEO L AUDIO R
ADVANCED
SURROUND STEREO/ DIRECT SIGNAL
SELECT MIDNIGHT/ LOUDNESS SB CH
MODE
TENING MODE
TONE QUICK SETUP
ON ODE
MCACC VIDEO INPUT
MULTI JOG
7.1ch* 4.1ch
6.1ch 5.1ch
2.1ch 3.1ch
7.0ch* 4.0ch
6.0ch 5.0ch
2.0ch 3.0ch
VSX_714_814.fm 11 ページ ２００４年１月２８日 水曜日 午前１０時１８分