Proel RM3000TR - Manuale (Pagina 8)

8
7. R OUTPUT (XLR output Ͳ BALANCED)
Same as above for the R INPUT.
8. POWER
ON/OFF switch: the LED shows the ON or OFF status of the transmitter.
9. PHONES
Auxiliary headphones output.
10. PHONES VOLUME
Volume potentiometer for the auxiliary headphones output.
11. MONO/STEREO
This switch combines the L & R inputs together and sends the resulting mono signal to both L & R
earphones channels. In case of a single channel input (L or R) this switch must be pressed in order to
send the same signal to both L & R earphones channels.
12. L INPUT METER
5 LED bar meter of L channel showing the input level. The last RED LED light up just above the nominal
input signal (+5 dBu): for getting the optimal RF transmission dynamic range, reduce the level of input
signal if the red LED lights.
13. R INPUT METER
Same as above for the R input channel.
NOTE: the bar LED shows the signal just before the RF transmitter channels, so after the MONO / STEREO
and the +10dB / 0dB switches.
14. +10 / 0 dB GAIN
When engaged this switch enhances the input signal of 10 dB: use it in case of lowͲlevel input signals.
15. CHANNEL SELECT
These switches are used for selecting the transmission channel: press and hold the UP or DOWN switch
until the display flashes, then press again the UP or DOWN switch to scroll the channels. After 6 seconds,
if noͲone switch is pressed, the display lights steady and the transmission starts on the selected channel.
16. CHANNEL DISPLAY
The 2Ͳdigit display shows the selected channel.
RM3000R BODY PACK RECEIVER
17. ANTENNA
This is the receiving antenna. It is short and flexible for the maximum user comfort: do not force it.
18. EARPHONES VOLUME
This control sets the earphones output level. We suggest to set a comfortable but not excessive level, in
order to avoid to stress or damage your ears. Read the safety notes at the beginning of this manual.
19. TONE
Use the TONE switch to EQ the signal. Four choices are available:
1. BASS and HIGH enhanced.
2. HIGH enhanced.
3. BASS enhanced.
4. FLAT response.
20. BATTERY COVER
Sliding down the lower part of the bodypack you can access the battery compartment.
21. POWER INDICATOR
This orange LED lights when the receiver is turned on.
22. BATTERY LOW
This red LED lights when the batteries are exhausted: replace the batteries as soon as possible.