Proel RM3000TR - Manuale (Pagina 7)

7
INTRODUCTION
Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.
DESCRIPTION
The RM3000TR is a UHF PLL controlled Wireless InͲear Monitoring System providing a reliable and high
quality signal transmission.
RM3000TR features 2 units: RM3000 transmitter and RM3000R body pack receiver. The system is equipped
as follow:
RM3000TR: RM3000 + RM3000R + EB10 earphones + AC/DC adaptor + carrying case
RM3000R: RM3000R + EB10 earphones (optional second receiver)
EB10: optional spare earphones
8 channel frequencies are available, allowing the possibility to use the apparatus with other wireless
equipment.
RM3000TR TRANSMITTER
See FIG. 1 at page 15:
1. ANTENNA
This is the transmitting antenna. Use only the antenna supplied with the system, screw it in and raise it
up during the use. In order to obtain an optimal reception, place the transmitter away from other metal
and no more than 50 mt. away from the receiver.
2. 12Ͳ15V DC
Socket for the AC/DC adaptor connection: use only the adaptor supplied with the system.
3. RF POWER
This selector sets the radio frequency carrier output power. Three levels are available:
L as Low for an RF power < 10mW
M as Medium for an RF power < 50mW
H as High for an RF power < 100mW
NOTE: for all European countries only L setting can be used.
4. L INPUT (combo XLRͲJACK input Ͳ BALANCED)
Left channel input: this is a female combo connector that accepts a XLR or a JACK plug from almost any
type of equipment with a balanced or unbalanced outputs. The XLR input is wired as follows:
Pin 1 = shield or ground
Pin 2 = + positive or "hot"
Pin 3 = Ͳ negative or "cold"
The JACK input is wired as follows:
Tip = + positive or "hot"
Ring = Ͳ negative or "cold"
Sleeve = shield or ground
When connecting an unbalanced signal, the connector must be wired as follows:
Pin2 / Tip = + positive or "hot"
Pin 1Ͳ3 / Sleeve = shield or ground
5. R INPUT (combo XLRͲJACK input Ͳ BALANCED)
Same as above for the Right channel.
6. L OUTPUT (XLR output Ͳ BALANCED)
This connector provides a balanced lineͲlevel signal from the L INPUT. Connect this to the input of
another audio equipment or another RM3000 transmitter.