Proel MLX3642 - Manuale (Pagina 23)

23
145. MONITOR LEVEL control
This controls the MONITOR output’s level.
146. TALKBACK Input
This is a female XLR connector, which accepts a balanced microphone input from a dynamic type microphone (no
phantom power). This is where to plug the talkback microphone used by the sound engineer to talk with the performers
on the stage or in the recording room.
147. MAIN switch
Engaging this switch you assign the TALKBACK mic signal to the MAIN MIX bus regulated by the MAIN MIX fader.
148. GROUP switch
Engaging this switch you assign the TALKBACK mic signal to the GROUP 1-4 bus regulated by the GROUP 1-4 faders.
149. AUX 1-4 switch
Engaging this switch you assign the TALKBACK mic signal to the AUX 1-4 bus regulated by the AUX 1-4 faders.
150. AUX 5-6 switch
Engaging this switch you assign the TALKBACK mic signal to the AUX 5-6 bus regulated by the AUX 5-6 pots.
151. TALKBACK level control
It adjusts the level of the TALKBACK input.
152. LAMP 5V usb socket
This USB connector provides +5V power supply for gooseneck LED lamps. Use only LED lamps with MAX 0.5W power
consumption. PROEL suggested types is USBLL02 (off/single/dual intensity switch, bright white LED) .
153. POWER switch
Make sure that all master output knobs are turned all the way down when powering your mixer up or down. Always
power on the mixer before your amplifiers and power down your mixer after powering down all amplifiers.
154. AC~ socket
Here’s where you plug in your mixer’s mains supply cord. You should always use the mains cord supplied with the mixer.
Be sure your mixer is turned off before you plug the mains supply cord into an electrical outlet.
155. FUSE holder
Here is placed the mains protection fuse. Please follow the instructions on page 10 of this manual to replace it.