Candy CF CCS 66 MX - Manuale (Pagina 37)

37
INSTALLATION - GAS CONNECTION
REGULATION OF THE MINIMUM FLOW :
To complete the by-pass for the regulation of the minimum flow (for the hob and the
oven) remove only the control knobs of the cooker with a metal control panel.
1. Once the by-pass screw is reached, proceed with the regulation on the hob burners as
follows :
a) natural gas (methane) :
- Turn the by-pass screw to the maximum, then unscrew it two turns.
- Set the knob on the "minimum" position (it stops turning) and tighten the by-pass screw
until you obtain a small flame, which must remain the same when you turn the knob back
from the maximum to the minimum position.
b) butane or propane gas : Regulate by turning the by-pass screw to the stop position.
2. To regulate the by-pass of the oven, regulate the screw placed in front of the thermostat
as follows :
a) Butane or propane gas :
- tighten the screw to the maximum without blocking it.
b) Natural gas
to check whether the by-pass regulation is correct, proceed as follows :
- light the oven placing the control knob on position maximum. You should obtain a
small flame (2 mm) which must remain the same when you turn the control knob from
position maximum to minimum. If the flame goes off, the by-pass flow is not sufficient. You
must unscrew the thermostat by-pass screw a little.
CAREFUL : If the by-pass flow is too high, it neutralizes the thermostat action.