English, Suggestions and recommendations – RCF VHF Diversity wireless michrophone system RX1000 Manuale d'uso

Pagina 25

Advertising
background image

ENGLISH

25

SUGGESTIONS AND RECOMMENDATIONS

TO PREVENT INTERFERENCES:
• Keep the transmitters at least 5-6 metres from every active receiver.

• The receiver antennas should not be too close to each other.

• Make sure the transmitter batteries are fully charged and efficient.

• Optimise the receiver squelch level.

PROBLEMS WITH THE SIMULTANEOUS USE OF MULTIPLE MICROPHONES:
• Absolutely avoid the use of two (or more) transmitters tuned to the same

frequency.

ADVICE TO FIND OUT THE INTERFERENCE ORIGIN:
• Make sure the radiomicrophone is actually the cause by switching off the

receiver and disconnecting the connection cables momentarily (to see if

the problem persists).

• Switch off all transmitters and check if all receivers go to “mute” status:

this allows you to verify the possible presence of external interfering

sources.

• Switch on one transmitter at a time, walking around in the room (or

outdoor) to find the worst condition and identify the receiver coming

out from the “mute” status. If one receiver not tuned to the frequency of

the used transmitter comes out from “mute” status, there is a problem of

intermodulation and it is therefore necessary to change the frequency /

model.

PREVENT FEEDBACKS:
• The acoustic feedback (usually a sharp whistling sound) occurs when a

microphone is used too close to loudspeakers; therefore it is necessary

to keep the distance.

• Turn down the radiomicrophone volume (receiver “AUDIO OUT” control).

• Do NOT aim the microphone capsule to loudspeakers.

PREVENT DROPOUTS:
• Reflections caused by walls in reinforced concrete or metallic structures

may cause “dropouts” (zones where it is not possible to get a perfect

radio transmission). It is therefore advisable to check beforehand the

reception quality where the mic. will be used. In case of dropouts, change

the location of the receiver and/or move the antennas (modifying their

inclination).

MAINTENANCE
Clean the plastic surfaces using a soft cloth dampened with non-alcoholic

detergent.

Advertising