Proel PLCNDXN - Manuale (Pagina 15)

15
SCENE (Step)
INSERT A SCENE:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.
- Select the desired chase via chase button. The respective led will be lit.
- Press the DISPLAY button in order to switch the display to step. The display will show the scenes (steps) in the chase.
- Select the scene were the scene will be inserted with BANK UP/DOWN buttons. E.g. if you want to insert a scene
between scene 5 and scene 6, press BANK UP/DOWN buttons so that the display will show STEP05.
- Press MIDI/REC button to prepare inserting. Now the display will show the next step (E.g. STEP06)
- Select the bank where the scene will be inserted via the BANK UP/DOWN buttons
- Select the scene you want to copy via SCENES button
- Press MIDI/REC button to insert. All leds on the panel will flash.
COPY A SCENE:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.
- Select the bank where the scene will be copied via BANK UP/DOWN buttons
- Select the scene to be copied by pressing the respective SCENES button
- Press the MIDI/REC button to prepare copying
- Select the bank where you want to copy the scene, via the BANK UP/DOWN buttons
- Press the desired SCENES button. All leds on the panel will flash.
DELETE A SCENE:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.
- Select the bank in which a scene will be deleted, via BANK UP/DOWN buttons
- Press and hold the AUTO/DEL button
- Press the SCENES button corresponding to the scene to be deleted
- Now you have deleted the scene. All leds on the panel will flash.
- All 240 DMX channels of the deleted scene will be set to 0.
DELETE ALL SCENES:
Caution: when you select this function, all programmed scenes will be irrevocably lost.
- Press and hold the BANK DOWN and PROGRAM buttons while disconnecting the device from the mains.
- Connect the device to the mains again.
SOUND CONTROL
- Pressing the MUSIC/BANK COPY button, the Music led will be lit. When the device receives a music signal, it will work in
Sound Control mode.
- Select the bank to be sound controlled via BANK UP/DOWN buttons
- You may adjust the fade time by the FADE TIME fader.
- Press a CHASE button, the chase will be sound controlled. You may press more then one chase to run them one by one.
- You may adjust the duration time via FADE TIME fader.
AUTO MODE
- To select the Auto Mode, press AUTO/DEL button until Auto led is lit
- Switch off all buttons SCANNERS 1 ÷ 12
- If no CHASE buttons are pressed, it will run bank automatically. Select the desired bank via BANK UP/DOWN buttons.
- Press a CHASE button, it will run the case automatically. You may press more then one chase to run them one by one.
- You may adjust the interval time between steps via SPEED fader , and adjust the duration time via FADE TIME fader
In auto mode, you can control each projector in manual mode. Press the respective SCANNERS button and move the sliders.
MIDI OPERATION
- Press and hold the MIDI/REC button for three seconds.
- Use the BANK UP/DOWN to select the DMX channel 01-16 to assign to MIDI channel
- Press and hold down the MIDI/REC for three seconds to store your setting and to deactivate MIDI setting.
- If you wish to give up your setting, tap any other button except BANK UP/DOWN to ext MIDI mode
This unit receives Note On signals wich enables to run 15 banks (01-15) of scenes, and 6 chases of scenes. In addition, black-out
function can be activated by MIDI signal.