Proel PLCNDXN - Manuale (Pagina 13)

13
CHANNEL SETTING
This device can control 12 scanners, each up to 16 channel.
OPERATION
MANUAL MODE
To select the manual mode, press AUTO/DEL button, until manual led is lit.
In manual mode (program led off), you can call up the connected scanners manually, and control them via the channel faders.
Please note that adjusted settings cannot be memorized.
Select the respective scanner via the respective SCANNER button. Adjust the desired function via the channels faders.
CHECK A BANK/SCENE
Select the bank you want to check via BANK UP/DOWN buttons. Select the scene you want to check via one of the SCENE button.
CHECK A CHASE:
Select the chaser you want to check via the CHASE button. Press DISPLAY button, the display will show the step in the chase.
Press BANK UP/DOWN buttons to see each scene.
Via the PAGE SELECT, button, you can ad just the channel faders from Ch.1 to Ch.8 (page A, led lit) to Ch.11 to Ch.20 (page B, led
lit) or both of them (page A and B, led lit together).
Via the DISPLAY button, you can switch the display of the faderway from DMX value (0 – 255) to percent (0 – 100%).
PROGRAMMING
A program (bank) is a sequence of different scenes (steps) that will be called up one after another. With this DMX operator, you can
program up to 30 different programs (banks) with up to 8 scenes (steps) each..
PROGRAMMING A PROGRAM:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.
- Select the desired program (bank 01 – 30) you will save via the BANK UP/DOWN button.
- Select the desired scanner via the SCANNER select button.
- Adjust the desired settings (the value will be shown in the display) via the respective channel faders.
- Press MIDI/REC button to prepare saving.
- Press one of the SCENE buttons in order to save the data. All leds on the panel will be flashing, indicating the data is
saved.
- Repeat the steps above, until the program is finished of the maximum number of steps (8) has been reached.
- Press and hold the PROGRAM button in order to exit programming mode.
RUNNING A PROGRAM:
- Press the BANK UP/DOWN buttons and select the desired program.
- Press the AUTO button, the Auto led will be lit.
- Adjust the program speed via the SPEED fader and the repetition rate via the FADE TIME fader.
- As an alternative, you can adjust the program speed by tapping the DISPLAY button twice. The time interval between the
two taps, corresponds to the program speed (up to 10 minutes).
CHECKING A PROGRAM:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.
- Select the desired program via the BANK UP/DOWN buttons
- Check every scene individually by pressing the respective SCENES button.
EDITING A PROGRAM:
- When programs have to been edited, it is necessary to modify a scene manually.
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.
- Select the program to be edited via the BANK UP/DOWN buttons
- Select the desired scanner via SCANNERS buttons
- Adjust the desired settings via the respective channel faders.
- Press MIDI/REC button to prepare a saving.
- Select the desired scene via the SCENES button, to save.
COPY A PROGRAM:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming mode. The program flash will flash.