Fulgor Milano FDW 8207 - Manuale (Pagina 34)

GB
32
OPERATING INSTRUCTIONS FOR MODELS FEATURED IN THE FIGURE
8
8.1 Control panel and wash programmes
1) On/Off button
2) Low salt indicator light (if fitted)
3) Low rinse aid indicator light (if fitted)
4) “Delay” delayed start selector
5) Quick wash / half load selector (if fitted)
6) Programme selector button
7) Multifunctional display
To open the door, pull forwards (an electrical safety
device will switch the machine off when the door is
opened).
15
1
6 5
4
2
3
7
1 7
1
6
6
STARTING THE DISHWASHER
After checking the quantities of regeneration salt (only in the salt container version) and of rinse aid, open the water faucet
completely, place the dishes in the baskets, fill detergent into the detergent container and add also detergent for the pre-
wash (if necessary).
Now proceed as follows:
Press the “ON-OFF” button , the display will light up and show the most recent programme performed.
PROGRAMME SELECTION
Press button (programme selector); the upper/lower washing symbol will appear on the Display and after
approximately 3 seconds the duration time for the selected programme will also appear. Select the wash programme based
on the type of crockery and dirt content.
START
Close the dishwasher door after selecting the wash programme; a buzzer (beep) will signal the start of the cycle.
ADDING MORE CROCKERY
If you need to add more crockery items, the wash cycle can be interrupted in the following manner: open the dishwasher
door slightly to avoid water spraying out and steam escaping from the machine; the programme will be paused and extra
crockery may be added. To resume the interrupted programme close the dishwasher door, the cycle resumes from the
point it was interrupted.
MODIFYING OR RESETTING A RUNNING PROGRAMME
This operation should preferably be performed if the programme has only just recently begun otherwise some detergent
may already have been used or washing water drained; in such case, additional detergent must be added (see paragraph
“Adding the detergent”).
To modify a programme which is already in progress open the door and press the Programme selector button for
approximately 6 seconds. A scrolling segment on the Display indicates the machine is in reset mode. Close the door
immediately.
N.B. The buzzer sounds to confirm the end of the RESET, while the text “End” is shown on the display. At this point
the machine is ready to be set again.
In the event of a sudden power cut, all settings remain memorised; the wash programme will resume from
the point at which it was interrupted.
PROGRAMME END
The dishwasher stops automatically once the wash cycle is terminated. The end of the wash programme is signalled by
a 3-beep buzzer which sounds 3 times. When the door is opened, the Display will light up and the text “End” will appear
on the screen for 10 seconds, after which the number of the most recent programme performed remains visible. To switch
off the appliance press the button . After each wash cycle, it is advisable to close the water supply tap to cut off the
dishwasher from the water supply network.
SUGGESTIONS: After the beeps signalling the end of the cycle, the door may be left ajar to accelerate the drying
phase. If the worktop above the dishwasher is delicate, open the dishwasher door completely or keep it shut until
taking out the crockery, to prevent steam from coming out.